Kamstrup MULTICAL 803, Technical Description, Page: 84 / 171

MULTICAL® 803
84
Kamstrup A/S · Technical description · 5512-2360_A1_
GB
_02.2019
It also appears from the table below that no matter how the SETUP loop is exited when the calculator is in operation,
the installation seal must be broken again and calculator top and base must be separated and reassembled if the
technician wants to regain access to the SETUP loop.
Transport state In operation
1. Primary key
Access to SETUP loop
Access to SETUP loop
locked
2. Timeout
Access to SETUP loop
Access to SETUP loop
locked
3. EndSetup
Access to SETUP loop
locked
Access to SETUP loop
locked
6.4.1 Change of parameters in SETUP loop
The technician can navigate to the SETUP loop from the USER loop by keeping the primary key activated for 5
seconds and then use the arrow keys to navigate to 3-SETUP, which can be accessed with a single touch of the
primary key. The SETUP loop does not include secondary readings and therefore, the index number always consists
of 4 digits. See the table with SETUP parameters on the next page. The arrow keys are used to switch between
readings.
In the SETUP loop, the primary key is used to access individual readings with the purpose of changing the parameter
in question. Pressing the primary key, the first digit of the parameter in question (the digit farthest to the left) starts
flashing. The flashing digit can now be changed through brief activations of the primary key. Switch between the
digits by pressing the arrow keys. You can freely switch to both right and left. When the desired setup is entered,
keep the primary key activated until “OK” appears on the display. The calculator has now saved the change and the
display shows the set values.
Depending on the calculator’s configuration, one or more menu items in the SETUP loop are displayed as “OFF”. This
means that the function is not available in the calculator, i.e. the function has been disabled during factory
programming. If you try to access these readings via the primary key, the frames around “OFF” are shown to indicate
that the function is not available in the calculator.