MULTICAL® 803
Kamstrup A/S · Technical description · 5512-2360_A1_GB_02.2019
49
The table below is a part of the type number overview, which shows the module type numbers. The table
distinguishes between modules with pulse inputs (In-A, In-B) and modules with pulse outputs (Out-C, Out-D).
Modules
Data + 2 pulse inputs (In-A, In-B)
10
Data + 2 pulse outputs (Out-C, Out-D)
11
M-Bus, config 2 pulse inputs (In-A, In-B)
20
M-Bus, config 2 pulse outputs (Out-C, Out-D)
21
M-Bus, confi Thermal Disconnect
22
Wireless M-Bus, configurable, 868 MHz + 2 pulse inputs (In-A, In-B)
30
Wireless M-Bus, configurable, 868 MHz + 2 pulse outputs (Out-C, Out-D)
31
Analog output module 2 x 0/4…20 mA
40
Analog output module 2 x 0/4…20 mA
41
PQT Controller
43
Kamstrup Radio GDPR + 2 pulse inputs (In-A, In-B)
51
LON FT-X3 + 2 pulse inputs (In-A, In-B)
60
BACnet MS/TP + 2 pulse inputs (In-A, In-B)
66
Modbus RTU + 2 pulse inputs (In-A, In-B)
67
2G/4G network 2 pulse inputs (In-A, In-B)
80
Modbus/KMP TCP/IP + 2 pulse inputs (In-A, In-B)
82
High Power Radio Router GDPR + 2 pulse inputs (In-A, In-B)
85
Note:
The pulse outputs C1 and C2 will always be identically configured and in the same way, the
outputs D1 and D2 will always be identically configured. All four outputs are configured
through the meter's PP code. Therefore, pay special attention to this when the modules are
installed in the meter so that they have the right module slots in relation to the equipment that
they must be coupled with.