Kamstrup MULTICAL 803, Technical Description, Page: 118 / 171

MULTICAL® 803
118
Kamstrup A/S · Technical description · 5512-2360_A1_
GB
_02.2019
Display readings in connection with Auto Detect Pt
①
Break the installation seal 1
and separate the calculator
top and base
②
Mount temperature sensors
on the temperature sensor
inputs on MULTICAL® 803 as
specified in paragraph 4.4
③
Assemble the calculator top
and bottom 2
④
Display duration is typically 5 s
Observe the flashing display
on MULTICAL® 803, which
indicates that the mounted
Pt type 3 is being searched
for
⑤
Display duration is 5 s
Observe the static display
on MULTICAL® 803, which
indicates that the Pt type
has been found and
registered 4
⑥
MULTICAL® 803
automatically switches to
the primary energy display
in the USER loop
1
Remember to restore the seal installation after Auto Detect Pt.
2 Note that MULTICAL® 803 has a built-in engagement delay of up to 20 seconds to ensure that all plug connections between
calculator top and base are established before a detection of Pt sensors and/or ULTRAFLOW® X4 is initiated.
3 If Auto Detect UF for ULTRAFLOW® X4 is switched on, the text in the upper right corner of the display will alternately show UF
and
Pt
. See more about Auto Detect UF in paragraph 8.1.1.
4 A config logging is carried out every time MULTICAL® 803 registers a change of Pt type on the temperature sensor inputs.