
Page 41 of 101
6.1.2.15 Adjusting the Edge Enhance
Optimize the image by enhancing image contour to make image boundary more clear.
Steps:
Move cursor to [Edge Enhance] menu item and press Set key to adjust it.
Rotate Select knob to highlight the [Edge Enhance] menu item, press Select knob item to confirmation
select [Edge Enhance] item, and then Rotate Select knob to adjust it.
6.1.2.16 Adjusting the Image Enhance
Increase the image resoultion by reduce the speckle noise.
Steps:
Move cursor to [Image Enhance] menu item and press Set key to adjust it.
Rotate Select knob to highlight the [Image Enhance] menu item, press Select knob item to
confirmation select [Image Enhance] item, and then Rotate Select knob to adjust it.
6.1.2.17 Adjusting the Acoustic Power
Acoustic power is adjusted to increase or decrease the transmitting frequency of the probe.
Steps:
Move cursor to [A. Power] menu item and press Set key to adjust it.
Rotate Select knob to highlight the [A. Power] menu item, press Select knob item to confirmation
select [A. Power] item, and then Rotate Select knob to adjust it.
6.2 Color Doppler Flow Imaging (Color) Mode
Color is a color flow imaging technology which adds the color-coded qualitative information concerning the
relative velocity and direction of fluid motion in the B-Mode image.
6.2.1 Entering the Color Mode
Steps for entering the Color mode are as follows.
1.
Select the appropriate probe and exam type, and optimize the B mode image.
2.
Press the Color key on the control panel to enter the color mode, as shown in Figure 6-3.