
Page 25 of 101
Standby
In standby mode, screen is closed, system is in low power status, the Power on/Standby button led
flickers in green back light.
The system enters the standby mode automatically when it is not used for a certain time.
You can also press the Power on/Standby button and select the [Standby] to enter the standby mode.
You can set the standby by the Preset key [System Preset] [Standby and Wait Time].
Powering off the system
Extra 20 seconds are needed for powering on the system if it is powered off in abnormal way last time.
Do not power off the system during system upgrade or data transmission.
Do not disconnect the power cable before the power off information disappears. Or, the files may be
damaged and patient data may be lost.
For safety and functionality of the system, regular maintenance should be performed as described in Chapter
12 System Maintenance.
Long-click the Power on/Standby button can turn off the system forcely but may cause data lose, avoid turn off
the system in this way unless it is necessary.
Press the Power on/Standby button on the system and select [Power off] to shut down the system.
3.5 Connecting the Probe
Disconnect the probe when the image is frozen or the system is shut down. Otherwise, probe and system
damage may happen.
Steps for connection are as follows.
1.
Place the probe cable upward and rotate the probe lock on the probe connector to the horizontal
direction, as shown in picture below.
2. Insert the connector into the probe port until secure.
3. Rotate the probe lock on the probe connector to vertical direction position to make it fixed,as shown in picture
below.