Juniper JUNOSE 11.2, Configuration Manual

Page: 83 / 772

•
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
•
Example
host1(config-subif-atm-vc)# oam-pvc manage 15
host1(config-subif-atm-vc)# exit
•
Use the no version to restore the default behavior, which disables F5 OAM VC integrity
on the router and restores the default value for loopback frequency, 10 seconds.
•
See oam-pvc.
oam retry
•
Use to configure F5 OAM VC integrity parameters on an ATM data PVC.
•
You can optionally specify the following values:
•
upRetryCount —Number of successive loopback cell responses, in the range 1–60,
for the router to receive before reporting that a PVC is up; default value is 3
•
downRetryCount —Number of successive loopback cell responses, in the range 1–60,
for the router to miss before reporting that a PVC is down; default value is 5
•
retryFrequency —Number of seconds, in the range 1–600, for the router to wait
between the transmission of loopback cells when it is verifying the state of the PVC;
default value is 1
•
To configure these VC integrity parameters, you must use the oam retry command in
ATM VC Configuration mode. There is no equivalent atm pvc command to configure
these parameters.
•
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
•
Example
host1(config-subif-atm-vc)# oam retry 5 6 3
host1(config-subif-atm-vc)# exit
•
Use the no version to restore the default values for the up retry count, down retry count,
and retry frequency parameters.
•
See oam retry.
Configuring Inverse ARP for Data PVCs
You can use the inarp command in ATM VC Configuration mode to enable Inverse ARP
(InARP) on a data PVC that resides on an ATM 1483 NBMA subinterface configured with
the
multipoint option. The PVC must use the default encapsulation method, aal5snap .
For more information about InARP, see “Configuring an NBMA Interface” on page 37.
For example, the following commands enable InARP with a nondefault refresh rate
(10 minutes) on a data PVC. The PVC uses
aal5snap encapsulation by default. Issuing
the exit command causes the configuration to take effect.
host1(config)# interface atm 3/2.1 multipoint
51 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM