Juniper JUNOSE 11.2, Configuration Manual

Page: 541 / 772

NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline hdlc interface
•
Use to set a statistics baseline for Cisco HDLC interfaces. The router implements the
baseline by reading and storing the statistics at the time the baseline is set and then
subtracting this baseline whenever baseline-relative statistics are retrieved.
•
Example
host1# baseline hdlc interface serial 2/0:1/1
•
There is no no version.
•
See baseline hdlc interface.
show hdlc interface
•
Use to display statistics for the specified HDLC interfaces.
•
You can specify the following keywords:
•
statistics —Displays interface statistics
•
delta —Specifies that baselined statistics are to be shown
•
status —Displays the operational status of all configured interfaces
•
closed —Displays interfaces with administrative status Closed
•
config —Displays configuration information
•
down —Displays interfaces with operational status Down
•
lower-layer-down —Displays interfaces with operational status LowerLayerDown
•
not-present —Displays interfaces with operational status NotPresent
•
open —Displays interfaces with administrative status Open
•
up —Displays interfaces with operational status Up
•
full —Displays configuration information, status, and statistics
•
filter —Specifies a CLI output filter
•
Field descriptions
•
interface status—State of the interface:
•
Up — Traffic can flow on the interface
•
Down — Traffic cannot flow because of a problem in the interface at the current
protocol layer
509 Copyright © 2010, Juniper Networks, Inc.
Chapter 16: Configuring Cisco HDLC