Juniper JUNOSE 11.2, Configuration Manual

Page: 442 / 772

3.
Assign the PPPoE service name table to the PPPoE major interface.
host1(config-if)# pppoe service-name-table myServiceTable1
interface fastEthernet
•
Use to select a Fast Ethernet interface.
•
Example
host1(config)# interface fastEthernet 4/1
•
Use the no version to remove IP from an interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
•
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
•
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
•
For information about specifying the Gigabit Ethernet or 10-Gigabit Ethernet interface
or subinterface, see “interface gigabitEthernet” on page 400 and “interface
tenGigabitEthernet” on page 400 on “interface tenGigabitEthernet” on page 667.
•
Examples
host1(config)# interface gigabitEthernet 1/0
host1(config)# interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)# interface tenGigabitEthernet 4/0/1
•
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
•
See interface gigabitEthernet.
•
See interface tenGigabitEthernet.
pppoe
•
Use to specify PPPoE as the encapsulation method for the interface.
•
This command creates a PPPoE major interface.
•
Example
host1(config-if)# pppoe
•
Use the no version to remove the PPPoE major interface.
•
See pppoe.
pppoe service-name-table
Copyright © 2010, Juniper Networks, Inc. 410
JunosE 11.2.x Link Layer Configuration Guide