Juniper JUNOSE 11.2, Configuration Manual, Page: 109 / 772

•
broadcast—Indicates pseudo-broadcasting
•
connection up—Indicates a point-to-point virtual circuit
•
Example 1
host1# show atm map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0 broadcast
ip 192.168.2.30 maps to VC 12 atm 2/0
Map list other-map : PERMANENT
ip 192.10.2.10 maps to VC 100 atm 2/1
ip 192.10.2.20 maps to VC 101 atm 2/1
ip 192.10.2.30 maps to VC 102 atm 2/1 broadcast
•
Example 2
host1# show atm map brief
Map list my-map : PERMANENT
Map list other-map : PERMANENT
•
Example 3
host1# show atm map my-map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0 broadcast
ip 192.168.2.30 maps to VC 12 atm 2/0
•
See show atm map.
show atm oam
•
Use to display F4 OAM statistics for an ATM interface.
•
You must specify a VPI value in addition to the required ATM interface specifier.
•
You can use the following keywords.
•
segment —Displays information about segment loopbacks
•
end-to-end —Displays information about end-to-end loopbacks
•
To see F4 OAM circuits that are open, use the show atm vc command.
•
Field descriptions
•
Sending End To End Loopback Cells—Enabled, disabled
•
Frequency—Frequency configured on this circuit
•
End To End OAM CC verification—Whether end-to-end CC verification is enabled or
disabled
•
OAM CC Type—Whether the circuit is a sink or a source, or both a sink and a source
•
OAM Current CC state
77 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM