Juniper JUNOSE 11.2, Configuration Manual

Page: 361 / 772

•
Use to set a statistics baseline for PPP interfaces—including MLPPP interfaces, either
individual serial (member link) interfaces or multilink (bundle) interfaces.
•
Use only the serial or mlppp keywords.
•
For serial interfaces, specify the interface location in the format
slot / port : channel / subchannel for CT3 modules.
•
For MLPPP interfaces, specify the interface location as the name of the MLPPP bundle.
•
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
•
When baselining is requested, the time since the last baseline was set is displayed in
hours:minutes:seconds or days/hours format. If a baseline was not set, the following
message is displayed instead:
No baseline has been set
•
Use the optional delta keyword with MLPPP show commands to specify that baselined
statistics are to be shown.
•
Example
host1# baseline ppp interface serial 2/0:1/1
•
There is no no version.
•
See baseline ppp interface.
Sample Display
Without Baseline
The following command displays PPP interface (including MLPPP interface) statistics
without baselining:
host1# show ppp interface statistics
PPP interface serial 2/0:4/1 is up
No baseline has been set
Interface statistics in out
packets 0 0
octets 572 684
errors 0 0
discards 0 0
PPP interface serial 2/0:5/1 is up
No baseline has been set
Interface statistics in out
packets 0 0
octets 572 684
errors 0 0
discards 0 0
PPP interface serial 2/1:4/1 is up
No baseline has been set
Interface statistics in out
packets 0 0
octets 572 684
errors 0 0
discards 0 0
PPP interface serial 2/1:5/1 is up
No baseline has been set
Interface statistics in out
packets 0 0
329 Copyright © 2010, Juniper Networks, Inc.
Chapter 9: Configuring Multilink PPP