Juniper JUNOSE 11.2, Configuration Manual

Page: 57 / 772

•
Use the no version to enable a disabled interface.
•
See atm aal5 shutdown.
atm aal5 snmp trap link-status
•
Use to enable SNMP link status traps on the AAL5 layer interface.
•
Example
host1(config-if)# atm aal5 snmp trap link-status
•
Use the no version to disable the traps.
•
See atm aal5 snmp trap link-status.
atm atm1483 advisory-rx-speed
•
Use to set an advisory receive speed for an ATM 1483 subinterface. This setting has
no effect on data forwarding. You can use it to indicate the speed of the client interface.
When traffic is tunneled with L2TP, the advisory receive speed is sent from the LAC to
the LNS. See LAC Configuration Prerequisites for additional information about the
advisory receive speed.
NOTE: If you specify an advisory receive speed greater than 4294967 kbps, the speed
is not accurately represented in the L2TP AVP, which is in bits per second (bps).
•
The range is 0–2147483647 kbps.
•
Example
host1(config-subif)# atm atm1483 advisory-rx-speed 2000
•
Use the no version to restore the default behavior—the RX speed is not sent to the
LNS.
•
See atm atm1483 advisory-rx-speed.
atm atm1483 mtu
•
Use to set the MTU size for an ATM 1483 subinterface.
•
The range is 256–9180.
•
Example
host1(config-subif)# atm atm1483 mtu 7800
•
Use the no version to restore the default size of 9180.
•
See atm atm1483 mtu.
atm atm1483 shutdown
25 Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring ATM