Juniper JUNOSE 11.2, Configuration Manual

Page: 509 / 772

•
snmp-trap link-status —Enables SNMP link status processing for the specified
interface in the specified bridge group; SNMP link status processing is disabled by
default
•
learn addressCount —Sets the maximum number of MAC addresses that the bridge
group interface can learn, where addressCount is an integer in the range 0–64000.
A value of 0 indicates that an individual bridge group interface can learn an unlimited
number of MAC addresses, up to the maximum number that the router supports.
•
Example 1—Creates a subscriber (client) bridge group interface for a bridge group
named westford02 with SNMP link status processing enabled
host1(config-subif)# bridge-group westford02 snmp-trap link-status
•
Example 2—Sets the maximum number of learned MAC addresses on the westford02
bridge interface to 1000
host1(config-subif)# bridge-group westford02 learn 1000
•
Example 3—Creates a trunk (server) interface for a bridge group named westford03
host1(config-subif)# bridge-group westford03 subscriber-trunk
•
Use the no version to remove the interface from the bridge group and to restore the
default value for the keyword you specified.
•
See bridge-group.
interface atm
•
Use to select an ATM interface or subinterface type.
•
Example
host1(config)# interface atm 3/2.1
•
Use the no version to remove the interface or subinterface.
•
See interface atm.
interface fastEthernet
•
Use to select a Fast Ethernet interface.
•
Example
host1(config)# interface fastEthernet 1/0.2
•
Use the no version to remove the interface or subinterface. You must issue the no
version from the highest level down; you cannot remove an interface or a subinterface
if the one above it still exists.
•
See interface fastEthernet.
interface gigabitEthernet
interface tenGigabitEthernet
•
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
•
Examples
477 Copyright © 2010, Juniper Networks, Inc.
Chapter 15: Configuring Transparent Bridging