Juniper JUNOSE 11.2, Configuration Manual

Page: 110 / 772

•
Ready—OAM CC is not enabled
•
Active—OAM CC cell flow is running
•
Activation Failed—OAM CC activation failed
•
Wait Activate—Waiting for interface to come up before the software sends the
activation request
•
Wait Activation Confirmation—Waiting for activation confirmation from the peer
•
Wait DeActivate—Waiting for interface to come up before the software sends the
deactivation request
•
Wait DeActivation Confirmation—Waiting for deactivation confirmation from the
peer
•
Segment OAM CC verification—Whether segment CC verification is enabled or
disabled
•
VP State—State of the VP: up, down
•
VP End To End Oam State
•
not managed—Circuit is in normal OAM state; no OAM fault conditions
•
AIS—Circuit is in AIS state
•
RDI—Circuit is in RDI state
•
VP Segment Oam State
•
not managed—Circuit is in normal OAM state; no OAM fault conditions
•
AIS—Circuit is in AIS state
•
RDI—Circuit is in RDI state
•
InOamF4Cells—Number of F4 OAM cells received
•
InOamF4CellsDropped—Number of incoming F4 OAM cells that were dropped
•
InOamF4EndLoopbackCells—Total number of F4 end-to-end loopback cells received
on this interface, which is the sum of the following counts:
•
InOamF4EndLoopbackCommands—Number of F4 end-to-end loopback
commands received
•
InOamF4EndLoopbackResponses—Number of F4 end-to-end loopback responses
received
•
InOamF4SegLoopbackCells—Total number of F4 segment loopback cells received
on this interface, which is the sum of the following counts:
•
InOamF4SegLoopbackCommands—Number of F4 segment loopback commands
received
Copyright © 2010, Juniper Networks, Inc. 78
JunosE 11.2.x Link Layer Configuration Guide