Juniper JUNOSE 11.2, Configuration Manual

Page: 431 / 772

5.
(Optional) Configure an access concentrator (AC) name on the PPPoE interface.
host1(config-subif)# pppoe acname CYM9876
6.
(Optional) Set up the router to prevent a client from establishing more than one
session using the same MAC address.
When the duplicate protection feature is enabled, multiple IWF PPPoE sessions
(sent from PPPoE clients to the PPPoE access concentrator) that contain the same
MAC address are still processed and can access network services until the maximum
number of PPPoE sessions configured per major interface (configured using the
pppoe sessions command) is reached.
host1(config-subif)# pppoe duplicate-protection
7.
Assign an IP address and mask.
host1(config-if)# ip address 192.6.129.5 255.255.255.0
8.
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3 through
7 using unique numbering.
Figure 42 on page 399 illustrates the interface stack for this configuration.
Figure 42: Example of PPPoE Stacking
encapsulation ppp
•
Use to specify PPP as the encapsulation method for the interface.
•
Example
host1(config-if)# encapsulation ppp
•
Use the no version to disable PPP on an interface.
•
See encapsulation ppp.
interface fastEthernet
•
Use to select a Fast Ethernet interface.
•
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide .
•
Example
399 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet