Juniper JUNOSE 11.2, Configuration Manual

Page: 145 / 772

polls within the verification interval, T392. The range is 5–30 seconds. The default is
10 seconds.
•
Use the frame-relay lmi-t392dce command to set the T392 polling verification timer
that specifies the maximum interval (in seconds) between the receipt of status inquiries
from the DTE equipment before it considers it as an error event. The range is 5–30
seconds. The default is 15 seconds.
•
Example
host1(config-if)# frame-relay lmi-n391dte 20
•
Use the no version to remove the current setting and set the default.
•
See frame-relay lmi-n391dte.
•
See frame-relay lmi-n392dce.
•
See frame-relay lmi-n392dte.
•
See frame-relay lmi-n393dce.
•
See frame-relay lmi-n393dte.
•
See frame-relay lmi-t391dte
•
See frame-relay lmi-t392dce
frame-relay lmi-type
•
Use to configure one of the local management interface types.
•
LMI provides configuration and status information relating to the virtual circuits
operating over Frame Relay.
•
LMI specifies polling mechanisms to receive incremental and full-status updates from
the network.
•
E Series routers conform to the following LMI specifications:
•
ansi —ANSI T1.617 Annex D
•
q933a —ITU-T Q.933 Annex A
•
cisco —Original Group of Four specification developed by DEC, Northern Telecom,
Stratacom, and Cisco
•
none —Suppresses LMI
•
The default is cisco .
•
Example
host1(config-if)# frame-relay lmi-type ansi
•
Use the no version to return to the default LMI type.
•
See frame-relay lmi-type.
interface pos
Use to configure a POS interface in slot/port format:
•
113 Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring Frame Relay