Juniper JUNOSE 11.2, Configuration Manual

Page: 481 / 772

•
aal5snap —Specifies a logical link control (LLC) encapsulated circuit;
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
•
aal5mux ip —Specifies a VC multiplexed circuit. This option is used for IP only.
•
Example
host1(config-subif)# atm pvc 1 0 32 aal5snap 0 0 0
•
Use the no version to remove the specified PVC.
•
See atm pvc.
encapsulation bridge1483
•
Use to configure bridged Ethernet as the encapsulation method on an interface, and
to optionally assign the MAC address to the interface.
•
Use the mac-address keyword to configure a specific MAC address for the interface.
Otherwise, the system MAC address is used. The same MAC address can be used on
multiple interfaces.
•
If the MAC address is configured, you must use the same MAC address whenever you
reenter the
encapsulation bridge1483 command for the interface.
•
The MAC address can be configured only when the interface is created. To change a
MAC address, you must remove the interface and create it again.
•
Example
host1(config-subif)# encapsulation bridge1483 mac-address 0090.1a01.1234
•
Use the no version, without the MAC address, to remove bridged Ethernet as the
encapsulation method on the interface.
•
See encapsulation bridge1483.
encapsulation ppp
•
Use to configure PPP as the encapsulation method for an interface.
•
Example
host1(config-subif)# encapsulation ppp
•
Use the no version to remove PPP as the encapsulation method on the interface.
•
See encapsulation ppp.
interface atm
•
Use to configure an ATM interface or subinterface type.
•
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the
slot / port .[ subinterface ] format.
•
slot —Number of the chassis slot
•
port —Port number on the I/O module
449 Copyright © 2010, Juniper Networks, Inc.
Chapter 14: Configuring Bridged Ethernet