Juniper JUNOSE 11.2, Configuration Manual

Page: 443 / 772

•
Use from Interface Configuration mode to assign a PPPoE service name table to a
PPPoE major interface for use by a static Fast Ethernet, Gigabit Ethernet, or 10-Gigabit
Ethernet interface.
•
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
•
Example
host1(config-if)# pppoe service-name-table myServiceTable1
•
Use the no version to remove the PPPoE service name table assignment.
•
See pppoe service-name-table.
Enabling PPPoE Service Name Tables for Use with Dynamic Interfaces
To enable a PPPoE service name table for use with a dynamic interface, add the service
name table to a profile that is dynamically assigned to the interface.
For complete details, see “Configuring a Dynamic Interface from a Profile” on page 559 in
“Configuring Dynamic Interfaces” on page 511.
To enable a PPPoE service name table for use with a dynamic interface:
1.
Create a profile by assigning it a name.
host1(config)# profile baseProfile
2.
Assign the PPPoE service name table to the profile as a PPPoE characteristic.
host1(config-profile)# pppoe service-name-table myServiceTable1
3.
Exit Profile Configuration mode.
host1(config-profile)# exit
4.
Configure a physical interface.
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1(config-if)# interface atm 3/0.1
5.
Configure an ATM PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
host1(config-subif)# atm pvc 10 100 22 aal5snap
6.
Apply the profile to the interface.
host1(config-subif)# profile pppoe baseProfile
7.
Enable the PPPoE dynamic encapsulation type.
host1(config-subif)# auto-configure pppoe
atm pvc
•
Use to configure a PVC on an ATM interface.
•
For details about specifying the mandatory VCD, VPI, VCI, and encapsulation type
parameters, see “atm pvc” on page 387.
411 Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Configuring Point-to-Point Protocol over Ethernet