JUKI HZL-600, Instruction Manual

Page: 57 / 108

53
Starting
point
Lock
stitches
To sew a bartack of the same length again…
when the length of the first bartack has been memorized,
● When the start/stop
button is pushed, the
machine starts to sew
and makes a u-turn
automatically at the same
point as the first bartack.
● When it comes to the
sewing end point,
push the reverse
stitch button.
* If you want to change the memorized length of the bar tack,
please select stitch pattern again.
Turning
point
3
Start sewing.
Push the start/stop button and the machine starts to
sew straight stitches.
4
When it comes to the turning point
push the reverse stitch button.
The machine goes back to the starting point by sewing
straight stitches and then it sews zigzag stitches to the
point where the reverse stitch button is pushed.
5
When the machine comes to the sewing
end point, push the reverse stitch button.
The machine sews lock stitches and stops.
Reverse stitch button
Start/stop button
55 54
Inserting zippers
* Make sure to use center needle position
(Stitch pattern No. Direct 1).
(right) (left)
2
Attach the zipper presser foot (B) to the
machine.
When sewing the left side of the zipper, place the
zipper under the right portion of the zipper presser
foot. When sewing the right side of the zipper, place
the zipper under the left portion of the foot.
1
Use the standard presser foot (A) to sew.
Place the fabrics face-to-face. Check the runstitching
length and the length of the zipper to be inserted.
Machine baste the zipper onto the fabrics.
Machine basting = zipper opening 1 cm
Machine basting ...
Stitch length “4”
Fabric
(wrong side)
Crotch end
Reverse stitch (1cm)
Runstitching ... Stitch length “Automatic”
Preparation before attaching zipper
Pattern No. Direct 1
Presser foot Zipper presser foot
(B)
Zippers are set in two different ways: by inserting into
the side seam of the garment and by centering in
position.
Attention
Turn OFF the power switch
before replacing the presser
foot.