JUKI HZL-600, Instruction Manual

Page: 23 / 108

Thread to guide
A
.
Hold the thread end and thread according
to the arrow marking.
* Make sure that the presser foot is raised.
Otherwise the machine is not correctly threaded.
3
4
Thread the guide
B
from the right-hand
side.
* It is easier to thread by pulling thread towards
left back side.
20
5
A
* Check that the thread take-up
is correctly threaded.
B
21
1
Lift the presser foot lifting lever.
1
2
3
4
5
Make sure to push the
needle to the top.
It is impossible to perform
stitching if the needle is not
correctly installed or a bent
needle is used. Pay close
attention as this will cause
machine malfunction.
Note:
2
Place a thread spool to the spool pin and
a spool cap onto the spool pin.
There are three types of the spool caps, large, medium
and small. Choose the size of spool cap according to
thread spool to be used.
19
Threading the needle thread
* Use the needle: No.11-16
and the thread: No.30-90.
* When twin needle is used,
the automatic needle
threader can not be used.
* Align the marking at the
hand wheel with the one
on the machine body.
Small spool
Large spool
Spool cap
Spool cap
Needle thread preparation
Attention Turn OFF the power switch
before winding the bobbin thread.