JUKI HZL-600, Instruction Manual

Page: 53 / 108

49
When changing the width of the buttonhole
When changing the density of the seam
Turn the zigzag width
adjusting dial/button.
Turn the stitch length
adjusting dial/button.
* The setting of the buttonhole width
and stitch length will be cancelled
when the power is shut down or
another pattern is selected.
wide
Turn to the left
Pushing "-"
The stitch length
becomes narrow
Narrow stitches Large stitch
narrow larger
Turn to the right
Pushing "+"
The stitch length
becomes larger
Turn to the left
Pushing "-"
The width becomes
narrow
Turn to the right
Pushing "+"
The width becomes
wide
F600 Only
F400 / F300
F600 Only
F400 / F300
narrow
* The width of buttonhole can be changed by ( ) option. (Refer to page 80)
51 50
Manual 2-step buttonhole
1
Set the manual buttonhole presser foot (I).
2
Pass the needle thread through the
hole of the presser foot and pull it out
sideways together.
Hole on the
presser foot
sewing
start point
Needle
thread
3
Bring down the needle on the sewing
start point and lower the presser foot.
* Turn the “zigzag width” and “stitch length”
adjusting dials before sewing when you want to
change the buttonhole width and density of the
seam.
4
Push start/stop button to sew.
* At this time, if the start/stop button is pushed, the
machine will stop sewing. And if the start/stop button
is pushed again, then the machine will continue to sew
the left side of the buttonhole.
Push the reverse stitch button when it
reaches the necessary length of the left
side of the buttonhole.
Sew bartack and the right side of the
buttonhole, then the machine sews
bartack and right side of the buttonhole.
Necessary length
Pattern No. Buttonhole 03
Presser foot Manual buttonhole
presser foot (I)
Reverse stitch button
Attention
Turn OFF the power switch
before replacing the presser
foot.