JUKI HZL-600, Instruction Manual

Page: 25 / 108

Release the threading lever and the
needle thread is threaded to the needle
eye.
Automatic needle threader
1
Lower the presser foot.
* The automatic needle threader sometimes
fails to thread the needle when the presser
foot is raised.
2
Thread to
A
and cut the thread with the
thread cutter.
4
21
3
Lower the threading lever until it comes
to a complete stop.
* Lower the threading lever slowly.
Threading lever
A
Thread cutter
Pull the thread backward.
Pull out the thread from the needle eye by approx.
10 cm or 4 inches long.
5
* Be careful that the cutter is inside.
Pulling up the bobbin thread
Basic operation:
You can start to sew without pulling up the bobbin
thread, however, if you want to sew with the
bobbin thread pulled out, follow the directions
below.
Pull out both needle and bobbin threads
by approx. 10 cm (4 inches) long and
pass them under the presser foot towards
the back of the machine.
1
Lift the presser foot and lightly hold the
end of the needle thread.
2
Turn the hand wheel towards you to move
the needle up and down. Loop of bobbin
thread will be pulled out when you will
pull the needle thread lightly.
3
22
23