JUKI HZL-600, Instruction Manual

Page: 51 / 108

49 47
Eyelet
punch
Stopper pin
6
Unplug the sensor pin after sewing.
7
Opening the buttonhole using a ripper.
[double bartack]
Pierce a stopper pin at the bartack and open the
buttonhole with a ripper. Be careful not to cut the
stitches.
[Keyhole buttonhole]
Place a cardboard under the buttonhole and make a
hole with the eyelet punch. Then pierce a stopper pin
at the bartack and open the buttonhole with a ripper.
Ripper
It will be easier to sew buttonholes on the thin fabrics
and/or near the overlapped sections, if the clamping
plate is used.
Clamping plate
1. Attach the buttonhole presser foot to
the presser foot holder, with the
clamping plate together.
2. Place the fabric between the presser
foot and the clamping plate.
* You can remove the clamping plate by holding .
● Buttonhole clamping plate
Caution
Turn off the power switch before
setting the clamping plate.
48
Buttonholes with gimp thread
prevent the buttonholes from
stretching and can make them
more secure. Use thread such as
hand-sewn buttonholes and similar
for gimp thread.
Buttonhole with gimp
Pattern No. Direct 0
Presser foot Buttonhole presser
foot (E)
Attention
Hook
1
Pass the needle thread through under the
presser foot and then draw the thread to
the side of the presser foot.
2
Put one end of gimp thread into the
notch at the front right side of buttonhole
presser foot, pull the gimp thread under
the presser foot and thread it at the hook
of the presser foot.
3
After threading at the hook, pull the gimp
thread back under the presser foot and
put it into the notch at the front left side
of the presser foot firml y.
4
Bring down the needle to the sewing start
point and lower the presser foot.
5
Sew the buttonhole.
6
Pull the left gimp thread to take off slack
and cut excess gimp thread.
Notch
Turn OFF the power switch
before replacing the presser
foot.