JUKI HZL-600, Instruction Manual

Page: 87 / 108

84
* Twin needle setting can not be done while a stitch
pattern other than those for twin needle sewing is
selected.
mark will be shown.
The twin needle setting can only be carried out
when suitable pattern is selected and center
needle position is selected at the same time.
Setting of twin needle sewing
Symbol of twin needle sewing will be
shown on the display.
* When in twin needle sewing, the stitch patterns will be
limited. In addition, the stitch length and zigzag width
will be also adjusted to suit the twin needle sewing.
* The setting is memorized even when the machine is
turned off and on.
* Select a stitch
pattern suitable for
twin needle sewing.
The sewing
image
Maximum 7.0 mm
* Maximum zigzag
width is 7.0 mm,
however, display
shows
.
5.0
7.0
Press
Press
Press
Press
Press
three times.
85
Twin needle sewing
* When using twin needles, make sure to set twin needle
sewing in Option and perform test sewing.
* When twin needle sewing, make sure to use thread size
smaller than No. 60.
* Make sure to use a twin needle with size of 2.0 mm (included
needle: 2.0 mm).
* When twin needle sewing, the sewing speed will become
slower.
Pattern
No.
Direct 1, 4
One-point 17, 19, 20, 21,
24~31, 34~38
One-point 17, 19, 20, 21,
24~29, 31~33
One-point 9, 10, 13~17
Presser
foot
Standard presser foot (A)
Manual buttonhole presser foot (I)
By using two needles beautiful decorative stitches
can be sewn.
2.0 mm
1
How to thread the needles
Place the supplementary spool pin.
Thread to the thread guide first. After that,
thread paths are same up from to .
Do not thread for right-hand needle.
Thread to right-hand and left-hand needles
separately.
* Automatic needle threader can not be
used. Thread each needle manually.
* Automatic thread trimmer can not be
used in case of twin needle sewing.
1
2
3
4
F600
F400
F300
Turn OFF the power switch before
replacing the presser foot.
Attention