![background image](http://html1.mh-extra.com/html/jcm-global/uba-pro-rt-series/uba-pro-rt-series_operation-and-maintenance-manual_3541085097.webp)
© 2020, JAPAN CASH MACHINE CO., LTD.
6 - 5
Calibration and Testing
UBA Pro RT/RQ™ Series Banknote Recycler
Section 6
Calibration
This section provides instructions for performing a
calibration of the Recycler Sensors.
When to Calibrate
Calibration should be performed when one of the
following four (4) conditions occur:
•
The Unit is disassembled or reassembled.
•
One of Sensors is removed or replaced.
•
The UBA Pro Main Board or RT/RQ Main Board is
removed or replaced.
•
Dirt adheres to the Sensors (Clean the Sensor first.
See “Cleaning Procedure” on page 2-15).
•
The Banknote Acceptance Rate becomes drastically
degraded.
Sensor Calibration
To calibrate the Recycler Sensors, proceed as
follows:
1. Remove electrical power.
2. Set each DIP Switch of the UBA Pro and the RT/
3. Connect the Unit to the PC.
(Refer to Figure 6-1 for the Tool Requirements
and Harness Connector locations).
4. Apply electrical power.
5. The
Green
and
Red
Status LEDs will be lit.
6. Launch the “
JCM Tool Suite Standard Edition
”
Application.
7. Click and hold-down the “
Service Mode
” Pull-
Down Menu.
8. Select “
Sensor Adjustment
a
).
9. Confirm that the Sensor Calibration Program
Screen appears (Figure 6-23).
10. Click the “
Sensor Calibration (RC-TQ)
”
button (Figure 6-23
a
).
11. Click the “
Start
”
button (Figure 6-24
a
) to
begin the Sensor Calibration.
NOTE: Refer to the UBA Pro Series
Universal Banknote Acceptor Operation
and Maintenance Manual for calibrating the
Sensors on the UBA Pro Unit.
Figure 6-21
Figure 6-21
Sensor Calibration 1
DIP Switch #8 ON
DIP Switches All OFF
ON
1
2
3
4
5
6
7
8
ON
1
2
3
4
5
6
7
8
Figure 6-22
Sensor Calibration 2
a
Figure 6-23
Figure 6-23
Sensor Calibration 3
a
NOTE: If the Start button is grayed out
(off), check the USB cable connection.
Figure 6-24
Figure 6-24
Sensor Calibration 4
a