Isuzu D-MAX 2020, Owner'S And Driver'S Manual

Page: 915 / 924

8-39
MAIN DATA
[Supply cable and routing]
1. Heavy-duty cable of a low electrical resistance should be used on long cable runs
to minimize voltage drop.
2. The cable shall be of a higher current capacity than the protection fuse, and the
correct fuse shall be fitted.
3. The cable should be as short as possible.
4. The cable shall be secured well clear of moving parts, (shock absorbers, steering,
drive shaft, control pedals, etc.).
5. The cable shall be secured well clear of the engine, exhaust system or other hot
items.
6. The supply cable run should, where possible, be separate from that of the in-
car entertainment equipment control cables, although they may pass through the
same holes in the chassis and body for ease of fitting; suitable grommets should
be fitted if additional holes are drilled.
7. The cable shall be supported, avoiding sharp bends, and shall not be subjected
to strain.
8. The cable shall be sited away from ignition coil, the high voltage circuits of the
ignition systems and electronic control units and, where possible, other vehicle
wiring.
5108428_sec08_MAIN DATA.indd 39 2020/11/20 15:36:36