EonStor S12E-R1132-4/G1133-2 Installation and Hardware Reference Manual
․
Do not use or leave the BBU near a heat source. Heat can
melt the insulation and damage other safety features of the
battery cells, possibly causing an acid leak and may result in
a fire or explosion.
․
Do not immerse the BBU in water or allow it to get wet. Its
protective features can be damaged and abnormal chemical
reactions may occur, possibly causing functional defects, acid
leaks, and other hazardous results.
․
Do not disassemble or modify the BBU. If disassembled, the
BBU could leak acid, overheat, emit smoke, burst and/or
ignite
․
Do not pierce the BBU with a sharp object, strike it with a
hammer, step on it, or throw it. These actions could damage
or deform it and internal short-circuiting can occur, possibly
causing functional defects, acid leaks, and other hazardous
results.
․
use the BBU, return it to Infortrend
To install a BBU, please follow these steps:
Step 1.
a medium size
Figure 2-24
If a BBU leaks, gives off a bad odor, generates heat,
becomes discolored or deformed, or in any way appears
abnormal during use, recharging or storage, immediately
remove it from the subsystem and stop using it. If this is
discovered when you first
or your system vendor.
2.9.2
BBU Installation Procedure
Remove the BBU bay metal cover from the chassis
by
loosening the retention screws using
Phillips screwdriver. (See
)
Figure 2-24: Removing the BBU Bay Metal Cover
g the BBU until it is fully inserted. (See
Figure 2-25
)
Step 2.
Install a BBU
by aligning it with the module bay and then
gently pushin
2-22
