EonStor S12E-R1132-4/G1133-2 Installation and Hardware Reference Manual
Figure
5
-25: Opening the Drive Tray Front Bezel
Step 4.
Remove the drive tray
by pulling it one inch away
from the drive bay. Wait for at least 30 seconds for the
disk drive to spin down (if the disk drive is removed not
because it is faulty but because of different reasons,
such as cloning the members of a logical drive or Copy
& Replace), and then gently and carefully withdraw the
drive tray from the chassis.
Step 5.
Remove the four (4) retention screws
that secure
the hard drive from the sides of the drive tray (two on
each side.)
Figure
5
-26: Loosening the Hard Drive Screws
Step 6.
Install the replacement hard drive.
Please refer to
the complete hard drive installation procedures in
Section 2.7.
5.8.
Replacing a MUX Kit
If a MUX kit is damaged or fails, often identified as drive-side signal
glitches, follow the instructions below to replace it:
Step 1.
Remove the drive tray from the drive bay in the
subsystem
. (See
Section 5.7.2, step 1-4
)
5-26
