Indmar Raptor JET SERIES, Operator'S Manual

Page: 35 / 82

4-3
FIRST TIME OPERATION AND BREAK-IN
© 2016 Indmar Marine Engines
4. WARNING! Operate the bilge blower for at least
4 minutes.
Start the engine (Refer to Section 5,
Engine Starting Procedures ) and allow it to reach
normal operating temperature; keep a close eye on
the gauges. If any of the gauges indicate an engine
problem, stop the engine immediately and bring the
boat to your Indmar dealer for assistance.
NOTICE:
Do not operate the starter motor for than 15 seconds
without a 2 minute cooldown period. Excessively long
cranking times will permanently damage the starter
motor and drain the battery.
BREAK-IN
Taking care now to break-in your new Indmar engine is
VERY important. When properly broken in, your engine
will last longer, run better and require fewer repairs over
its lifetime. Your new Indmar engine does not require
an elaborate break-in procedure, just a little care and
common sense for the first 10 hours.
Break-in Tips
x
Always let engine warm up to normal operating
temperature before accelerating.
x
Avoid fast accelerations and don’t carry (or pull) a
heavy load during this period.
x
If your boat is equipped with ballast tanks, do not use
them during the first 10 hours.
x
Check engine fluid levels frequently. During the first
50 to 100 hours, an engine can use more oil than
usual. Maintain oil at proper levels at all times but do
not overfill.
x
Vary your boat speed during break-in. Do not run at
the same speed very long.
x
Observe gauge readings and check for loose
mountings, fittings, nuts, bolts and clamps.
x
Report abnormal operation, noises or vibrations to
your dealer.