Indmar Raptor JET SERIES, Operator'S Manual

Page: 37 / 82

5-1
© 2016 Indmar Marine Engines
Section Five
ENGINE STARTING PROCEDURES
Before operating or maintaining the engine, review
“Safety” on page 1-1.
NOTICE
Current fuel injected engines are equipped with a feature
called “Smart Start.” When the key is advanced to the
START position, the starter will remain engaged and will
crank the engine for 8 seconds or until the engine starts,
whichever happens first. This same feature will prevent
accidental engagement of the starter when the engine is
running.
NOTICE
Some boats are equipped with a pushbutton start
instead of a key switch. Pushing the start button is the
same function as turning the key to the start position.
HOW TO START YOUR ENGINE
1. WARNING! Operate the bilge blower for at least
4 minutes.
Run the blower for 4 minutes to remove
explosive gasoline and battery fumes from the
engine compartment.
ON
BLOWER
OFF
INDM-A011
Figure 5.1 – Typical Blower Switch
2. Perform the Pre-Start Checks. Refer to Section 3.
3. Move the shift control lever to the NEUTRAL position.
Pull out the neutral safety lever (if equipped). Without
advancing the throttle lever, turn the starter key to
START position.
NOTICE
The throttle should be in the neutral position with the
neutral detent button on the shift control box pulled out.