Ikegami FA-97, Operation Manual

Page: 63 / 156

3.3 Power Connection
HDK-97C 1303 VER1 (U)
47
INS
T
ALL
A
T
IO
N
and CO
NNE
C
T
IO
N
3
3.3 Power Connection
There are two ways to supply power to the camera. Select the power supply according to the system con fi guration and operating
system.
●
To supply from the POWER (External power)
Directly connect the camera and the POWER via the DC POWER cable. Use the POWER speci fi ed as DC11V to 16V (60W or
more).
●
To supply from the CCU
Connect the camera and the CCU via the fi ber cable. The fi ber cable contains a power conductor.
Note:
Make sure that the camera POWER switch is OFF before connecting the power. Refer to "Make Sure the Power Switch is OFF" (page
33) for how to check the power.
Power Supply from POWER
This section explains how to supply the power from the POWER (external power). For the details on the POWER, refer to the
instruction manual accompanying the POWER to be used. This section describes the POWER which has a form as shown below.
MIC-1
MIC-2
DC IN
Q-TV/GL
EARPHONE
+12V
OFF +48V
MON
MON SDI SDI OUT
I/O
DC OUT
Camera rear view
POWER indicator
POWER
AC plug
Power outlet
DC IN connector
POWER switch
DC OUT connector
DC POWER cable
1
Make sure the POWER switch on the POWER is OFF.
2
Insert the AC plug of the POWER into the power outlet.
3
Connect the DC OUT connector on the POWER and the DC IN connector on the camera via the DC POWER
cable.
4
Turn the POWER switch on the POWER ON.
The POWER indicator on the POWER will light.