Ikegami FA-97, Operation Manual

Page: 108 / 156

5.2 Settings from the Menu
92
HDK-97C 1303 VER1 (U)
■
FILE SET
FILE SET creates a lens fi le.
To change the settings, select "LENS SELECT" on MENU (3/3), then "FILE SET."
The following explains the set values, descriptions, and setting procedures.
Set Value De s cription
OFF (default) Does not create lens files.
MANUAL Stores the current lens status as a file. ("LENS No. x" will be displayed at the bottom of the screen.)
AUTO
Starts auto setup for lens file creation. ("PUSH SET -> START" will be displayed and flash at the
bottom of the screen.)
Chart on which Kent paper, etc. has been pasted
and the entire surface is a uniform white.
Illumination
meter
Light
Camera
Tripod
Picture monitor
(connect if required)
Coax cable
Light
WFM
MON SDI OUT connector
Note:
- The creation of lens fi le requires precise adjustment; therefore, lens fi les are protected against unintentional update by the S11-4 DIP
switch of the MPU module.
- When creating a lens fi le, set the optical fi lter to ND:100% and the ECC fi lter to 3200K. Also con fi rm that no special effect fi lter is
attached to the front of the lens or internal fi lter disk. If a special effect fi lter is attached, it may not be possible to correctly create the
lens fi le.
- When operating the DIP switch (S11) in the MPU module, turn the POWER switch of the camera OFF once.
1
Set the camera for level setup.
- Mount the standard lens, which is used as a reference lens, to the camera.
- Chart on which Kent paper, etc. has been pasted and the entire surface is uniform white is used for the photographic
subject.
- Use an illumination meter to adjust the light so that light is evenly distributed over the whole chart.
2
Dip switch S11-4 On allows creation of a lens file, Off prohibits creation of new lens files.