Ikegami FA-97, Operation Manual

Page: 57 / 156

3.2 Camera and Peripheral Installation and Connection
HDK-97C 1303 VER1 (U)
41
INS
T
ALL
A
T
IO
N
and CO
NNE
C
T
IO
N
3
Mounting and Removing the Len s
■ Mounting the Lens
This section explains how to mount the lens to the camera.
Be sure to place the camera on a tripod or on a
fl at, level, stable surface when you mount the lens. The lens can be mounted to the
HDK-97C either by BTA mounting method.
1
Before proceeding any further, remove the lens
cap by pushing up the lens lock lever.
③
②
Push down the lens lock lever
to secure the lens to the camera.
Align the notches and insert the lens
into the camera lens mount.
2
Align the pin of the lens with the notch of the
camera lens mount, and horizontally insert the
lens into the camera lens mount.
Support the lens with your hand to prevent it from
falling.
3
Secure the lens to the camera.
Push down the lens lock lever to secure the lens to the
camera. Make sure there is no play.
4
Connect the pigtail cable to the lens connector.
Align the pins on the pigtail cable with the lens
connector and push until it is locked.
⑤
④
Secure the pigtail cable
with the cable clamps.
Connect the pigtail cable.
5
Secure the pigtail cable with the cable clamps to
remove any slack.
CAUTION:
Do not hold the lens housing to support the entire
camera. An excessive force applied to the mount will
cause damage.