Ikegami FA-97, Operation Manual

Page: 76 / 156

4.3 Turning ON Power
60
HDK-97C 1303 VER1 (U)
4.3 Turning ON Power
The procedure for turning the power ON/OFF depends on how power is supplied to the camera. This section explains how to
supply power from the POWER (External power) and the CCU.
Power Supply from POWER
Before turning the camera ON, make sure that the POWER switch on the POWER is ON and the POWER indicator lights.
Reference:
Refer to "3. INSTALLATION and CONNECTION", "Power Supply from POWER" (page 47) for how to connect the camera to the AC
pack and how to turn the power ON.
1
Set the POWER switch on the camera to EXT.
Power will be supplied to the camera, and the POWER indicator will light in green.
Power Supply from CCU
Before turning the camera ON, set the switches to the following positions in normal operations. The power is turned ON/OFF by
the MAIN POWER switch on the CCU.
Switch Switch Po s ition
Camera POWER switch BS/CCU
CCU
CCU MAIN POWER switch OFF
HEAD POWER switch I
OCP(*) CAM POWER switch ON
(*) When OCP-200 is used, the setting for the CAM POWER switch is not necessary.
1
Turn ON the MAIN POWER switch on the CCU.
The CCU checks the fi ber cable connection and supplies power to the camera if the cable is properly connected. The
CABLE indicator on the CCU will indicate the connection status of the fi ber cable.
NORMAL (green) : Lights when the fi ber cable is normally connected. The CCU checks the camera code transmitted
from the camera to con fi rm that the camera is an applicable model, and then supplies power to
the camera.
OPEN (red) : Lights when the fi ber cable is not connected or there is an "open" in the fi ber cable.
SHORT (red) : Lights when a short circuit occurs in the fi ber cable due to a cause such as water.