Idis ID391H, User Manual

Page: 21 / 98

Digital Video Recorder
13

Network Service
– FEN Server Info.: Clicking the Set up… button allows you to enter the FEN server information.

Server, Port:
Enter the IP address (or domain name) and port number
of the FEN server.
– Use FEN:
Enables the FEN function. Clicking the
Set up…
button allows you to register the DVR on the
FEN server.

Name: Enter the DVR’s name to be registered on the FEN server. Click
the
Name Check
button to check if the name you entered can be used.
Clicking the OK button registers the name as a FEN name of the DVR.
NOTE: The FEN function allows you to connect to the DVR from remote sites using either the dynamic IP
addresses or the domain name. For the FEN function to work properly, the DVR’s FEN name should be registered
on the FEN server, and the FEN server settings should match the settings registered on the FEN server. Any
changes on the FEN server might cause improper operation.
NOTE: The FEN registration is limited to only one FEN server. The DVR cannot be registered to multiple FEN
servers.
NOTE: When FEN function is enabled, it is not necessary to set up port forwarding manually. However, remote
connection to the DVR might not be available depending on the network connection environment of the DVR or
remote system when the FEN function is enabled. If it is the case, you should set up port forwarding for the DVR
manually in the NAT (Network Address Translation) device to which the DVR is connected.
– Use RTSP:
Enables the RTSP service.

Set up network port:
Click the button and set up network port number.

Internet Protocol (TCP/IP) properties: See Appendix 1 — Network Setup .