IBM System x iDataPlex dx360 M4 7912, Service Manual

Page: 357 / 400

System-board tray cover
DIMM
Microprocessor
Power-supply
paddle card
3.5-inch
simple-swap
backplate
3.5-inch
simple-swap
hard disk drive
3.5-inch
filler panel
System-board tray
Dual-port
network adapter
(Optional)
Dual-port
network adapter
filler
2.5-inch
simple-swap
backplate
1.8-inch
simple-swap
backplate
1.8 & 2.5-inch
filler panel
2.5-inch
simple-swap
hard disk drive
1.8-inch
simple-swap
hard disk drive
2.5-inch
simple-swap
drive cage
PCI riser
assambly
Heat sink
1.8-inch
simple-swap
drive cage
Note: You might have to remove component fillers or covers before you can install
some components.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 275.
2. Reinstall the microprocessors and heat sinks (see “Installing a microprocessor
and heat sink” on page 328).
3. Reinstall the DIMMs (see “Installing a memory module” on page 310).
4. Reinstall the power-supply paddle card (see “Installing a power-supply paddle
card in the tray” on page 302).
5. Reinstall the dual-port network adapter, if you removed any (See “Installing the
optional dual-port network adapter” on page 322).
6. Reinstall the riser cards (see “Installing a PCI riser-card assembly on the
system-board tray” on page 303).
7. Install the hard disk drive bracket and cable assembly.
8. Reinstall the simple-swap SAS/SATA drive cage, if you removed one (see
“Installing a simple-swap SAS/SATA drive cage” on page 300).
9. Reinstall the hard disk drives, if you removed any (See “Installing a
simple-swap hard disk drive” on page 294).
Chapter 5. Removing and replacing server components
339