IBM SelectaDock III, User Manual

Page: 86 / 134

Checking the ThinkPad and SelectaBase Combination
Check whether the computer runs correctly when docked to the
SelectaBase. Do the same job on your computer after docking to it
to the SelectaBase
If you cannot run the same job that created your problem, go to the
next section.
1
Dock your computer to the SelectaBase and reconnect all
external devices to the SelectaBase.
2
Run the same jobs.
Did the same problem remain?
Yes The SelectaBase is causing the problem. Refer to the
SelectaBase setup guide to resolve the problem.
No Go to the next section.
Checking the SelectaDock III system
You are here because your problems occur only when you use the
computer docked to the SelectaDock system.
1
Dock your SelectaBase and the computer to the SelectaDock
III. Then connect the ac power cord to the SelectaDock III, but
do not turn the power on yet.
Did the docked indicator on the SelectaDock III panel turn
on?
Yes The SelectaDock III detected that your computer is
docked. Go to the next step.
No Your computer is not docked correctly. Go to “Setup
Problems” on page 6-13, and take the corrective
actions provided.
6-8
IBM ThinkPad SelectaDock III User's Guide