IBM SelectaDock III, User Manual, Page: 21 / 134

Attaching the SelectaBase to the SelectaDock III system
The following procedure describes how to attach the SelectaBase to
the SelectaDock III system.
Note:
The picture shows a SelectaBase 770 port replicator. To
attach the SelectaDock Base Model I to the SelectaDock III
system, do the same procedure.
1
Make sure that the security key on the SelectaBase is set to
the Unlock position.
2
Remove the connector cover by pulling out the hooks on both
sides
1
; then lift up the cover
2
.
Chapter 1. Introduction
1-11