Installing the Expansion Unit in a Rack
10. From the rear of the rack, reinsert the two 6-32 screws
.1/
on
the rear of the expansion unit and tighten the screws firmly.
Rear of Rack
11. Install the CRUs.
Note: Refer to Chapter 4, “Installing and Replacing Devices” on
page 35 for instructions on installing the CRUs into the
expansion unit.
12. Connect the power cord to the rear of each power supply.
Remove the nut and wrap the clamp around the power cord
approximately eight inches from the end. Reattach the nut and
tighten securely.
Note: The purpose of this clamp is to prevent the accidental
unplugging of the power cord from the power supply.
For information about cable management, visit the following IBM
World Wide Web site:
http://www.pc.ibm.com/support/
.
Chapter 3. Rack Installation
31
Summary of Contents for EXP15
