Turning the Expansion Unit On and Off
Turning the Expansion Unit On and Off
This section contains instructions for turning the expansion unit on
and off under normal and emergency circumstances.
Note: If you are turning on the expansion unit after an emergency
shutdown or power outage, refer to “Restore Power After an
Emergency” on page 58.
AC Power Connectors
AC Power Switches
Turning On the Power
Use this procedure to turn on the power for the initial start-up of
the expansion unit.
1. Verify that:
a. All communication and power cables are plugged into the
back of the expansion unit and an ac power outlet.
b. All hard disk drives are locked securely in place.
c. The option switch on the expansion unit is set correctly.
d. Check the system documentation for all the hardware
devices you intend to power up and determine the proper
start up sequence.
Note: Be sure to power on the IBM Netfinity EXP15 prior to or
at the same time as the system unit.
2. Turn on the power to each device, based on this powerup
sequence.
54
IBM Netfinity EXP15 Installation and User's Handbook
Summary of Contents for EXP15
