IBM 9114-275 - IntelliStation POWER 275, Service Manual

Page: 269 / 377

Bezels
The following procedures describe the removal and replacement of the system bezel. Before performing
the following procedures, read “Safety Notices” on page ix.
Removing the Front Bezel
To remove the front bezel, do the following:
1. Remove the bezel door as described in “Removing the Bezel Door” on page 250.
2. Press down on the two bezel-release levers.
3. Pull the top of the bezel out and away from the system.
4. Gently pull the bezel up and off the base, releasing the lower bezel locking tabs.
1
3
2
5
6
4
1 Model 275 4 Front Door
2 Bezel-Release Levers 5 Lower Bezel Locking Tabs (2)
3 Front Bezel 6 Lower Bezel Retaining Slots (2)
Replacing the Front Bezel
To replace the front bezel, do the following:
1. Place the two lower bezel locking tabs into the retaining slots located on the system base.
2. Rotate the bezel up toward the top of the system, ensuring that the aligning pins are aligned with their
mating holes located on the system.
3. Gently push the bezel in until the two bezel release levers are seated in their respective slots.
4. Replace the bezel door as described in “Replacing the Bezel Door” on page 250.
Chapter 9. Removal and Replacement Procedures
251