IBM 9114-275 - IntelliStation POWER 275, Service Manual

Page: 181 / 377

Service Processor Error Codes
Attention: Follow the procedure defined in the “Checkpoint and Error Code Index” on page 134. If you
replace FRUs or perform an action and the problem is still not corrected, go to “MAP 1548: System
Processor Problem Isolation” on page 90 unless otherwise indicated in the tables.
If you replace FRUs and the problem is corrected, go to
″
MAP 0410: Repair Checkout
″
in the RS/6000
Eserver
pSeries Diagnostic Information for Multiple Bus Systems .
Table 6. Service Processor Error Codes.
Error Code Description Action/
Possible Failing FRU
406x 0002 System unit backplane fault System unit backplane
Location: U0.1-P1
406x 0003 Scan interface basic assurance tests detected
processor fault
System unit backplane
Location: U0.1-P1
406x 000E Processor capacity card Operator panel
Location: U0.1-L1
406x 0010 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M5
406x 0011 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M7
406x 0012 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M4
406x 0013 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M2
406x 0014 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M6
406x 0015 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M8
406x 0016 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M3
406x 0017 Memory DIMM fault Memory DIMM
Location: U0.1-P1-M1
406x 00B7 Insufficient hardware resources were detected to
continue IPL of the system after processor sub
system testing and initialization was completed.
Go to “MAP 1540: Problem Isolation Procedures”
on page 87
406x 00D1 Informational message Informational message
406x 0100 Memory quad A failure Go to “MAP 1240: Memory Problem Resolution”
on page 55
406x 0101 Memory quad B failure Go to “MAP 1240: Memory Problem Resolution”
on page 55
Chapter 5. Error Code to FRU Index
163