IBM 8500R - Netfinity - 8681, Hardware Maintenance Manual

Page: 253 / 290

DANGER
To avoid a shock hazard, do not connect or
disconnect any cables or perform installation,
maintenance, or reconfiguration of this
product during an electrical storm.
To avoid shock hazard:
Ÿ The power cord must be connected to a
properly wired and grounded receptacle.
Ÿ Any equipment to which this product will
be attached must also be connected to
properly wired receptacles.
When possible, use one hand to connect or
disconnect signal cables to prevent a
possible shock from touching two surfaces
with different electrical potentials.
Electrical current from power, telephone, and
communications cables is hazardous. To
avoid shock hazard, connect and disconnect
cables as described following when
installing, moving, or opening covers of this
product or attached devices.
To Connect
1. Turn Everything OFF.
2. First, attach all cables to
devices.
3. Attach signal cables to
receptacles.
4. Attach power cord(s) to
outlet.
5. Turn device ON.
To Disconnect
1. Turn Everything OFF.
2. First, remove power cord(s)
from outlet.
3. Remove signal cables from
receptacles.
4. Remove all cables from
devices.
NOTE: In the UK, by law, the
telephone cable must be
connected after the power cord. NOTE: In the UK, the power
cord must be disconnected after
the telephone cable.
Related service information
245