IBM 8500R - Netfinity - 8681, Hardware Maintenance Manual

Page: 123 / 290

2. Remove the filler panel
.1/
from the empty hot-swap
bay by inserting your finger into the depression at the
left side of the filler panel and pulling it away from the
server.
Note
If you are installing a slim-high drive, you must
separate the slim filler bezel from the tray, and
insert the slim filler bezel into the top of the hard
disk drive cage. Otherwise, store the filler panel
in a safe place.
3. Install the hard disk drive
.2/
in the hot-swap bay:
a. Remove the new drive assembly from the
static-protective package.
b. Touch the static-protective package containing
the drive assembly to any unpainted metal
surface on the server. Then, remove the drive
assembly from the static-protective package.
c. If you are installing a slim-high drive, separate
the slim filler bezel from the tray, and insert the
slim filler bezel into the top of the hard disk drive
cage.
d. Ensure that the tray handle
.3/
is open (that is,
perpendicular to the drive).
e. Align the drive assembly so that it engages the
guide rails in the bay.
f. Gently push the drive assembly into the bay until
the drive stops.
g. Push the tray handle to the closed (locked)
position.
4. Check the hard disk drive status indicators to verify
that the hard disk drives are operating properly.
Note
If the server has a ServeRAID adapter installed,
refer to the ServeRAID adapter documentation
for details about configuration requirements.
Record the configuration information.
Netfinity 8500R - Type 8681
115