IBM 8500R - Netfinity - 8681, Hardware Maintenance Manual

Page: 157 / 290

Removing the processor housing
assembly:
To remove the processor housing
assembly:
1. Run the shutdown procedure for the operating
system. Turn off the server and peripheral devices,
and disconnect all external cables and power cords
(see “Preparing to install options” on page 134); then,
remove the front bezel (see “Removing the front
bezel” on page 137).
2. Remove the three processor fans:
a. Pull the fastener
.1/
in the top center of the fan
housing
.2/
. This places the fastener in the
unlocked position.
b. Pivot the fan downward and remove it from the
server.
c. Repeat steps 2a and 2b for each additional fan.
Refer to the following illustration while you perform
the steps in this section.
3. Open the two latches
.1/
at the top of the processor
housing assembly
.2/
. Fully extend the latches.
4. Pull the processor housing assembly partially out of
the server, approximately 203.2 mm (8 in.).
Netfinity 8500R - Type 8681
149