IBM 8500R - Netfinity - 8681, Hardware Maintenance Manual

Page: 34 / 290

necessary, see “Using the administrator password
menu” on page 27 for details.) Start the
Configuration/Setup Utility program and change the
power-on password as previously described in this
section (see steps 1 through 4).
Ÿ
You can change the position of the Password
override jumper, as described in “Jumper settings” on
page 125.
Ÿ
You can remove the battery and then install the
battery. See “Battery replacement” on page 49.
To set a power-on password:
1. Select Power-on Password from the System
Security menu; then, press Enter.
The Power-on Password menu appears.
2. Type the password in the Enter Power-on Password
data field.
You can use any combination of up to seven
characters (A–Z, a–z, and 0–9) for your power-on
password. Keep a record of your password in a
secure place.
3. Move the cursor to the Enter Power-on Password
Again data field and type the password again.
Note
A message appears if the two passwords do not
match. If this happens, press Esc to cancel the
request and return to the System Security menu.
4. Select Change Power-on Password to save the new
password; then, press Enter.
To delete a power-on password:
1. Select Power-on Password from the System
Security menu; then, press Enter.
The Power-on Password menu appears.
2. Select Delete Power-on Password; then, press
Enter.
3. A confirmation window appears. Press Enter to
delete the power-on password. Press Esc to cancel
the request and return to the System Security menu.
To allow the system to start in unattended-start mode
when a power-on password is set:
1. Select Power-on Password from the System
Security menu; then, press Enter.
The Power-on Password screen appears.
2. Select Allow for unattended boot with password.
Press the Left Arrow (
←
) key or Right Arrow (
→
) key
to toggle the entry to On.
26
Netfinity Server HMM