IBM 8500R - Netfinity - 8681, Hardware Maintenance Manual

Page: 136 / 290

5. Reinstall the I/O function card:
a. Refer to the illustration in step 1a on page 126
while you perform the steps in this procedure.
b. Carefully grasp the I/O function card by its top
edge, and insert the tabs on the bottom edge of
the metal connector plate into the matching
openings on the server back panel.
c. Align the I/O function card with the guide on the
opposite end of the adapter and the slot on the
I/O board.
d. Press the I/O function card firmly into the slot.
Attention: When you install the I/O function
card in the server, be sure that it is completely
and correctly seated. Incomplete insertion might
cause damage to server components.
e. Reinstall the I/O function card retention bracket
that you removed in step 1d on page 127 by
pressing in the fastener on the bracket.
f. Insert the two screws that you removed in step
1c on page 127.
g. Connect the cables that you disconnected in
step 1b on page 127. See “I/O function card
component locations” on page 120 for the
connector locations on the I/O function card.
6. Reinstall the server top cover or front access cover
and connect the cables (see “Completing the
installation” on page 56).
128
Netfinity Server HMM