IBM 3745 Series, Installation And Maintenance Manual

Page: 91 / 270

Symptom / Error FRU / Action
1162
Serial port configuration error. 1. Run Configuration
2. Serial Adapter (if installed)
3. System Board
11XX
Not listed above. 1. System Board
1201 1. System Board
2. Any Serial Device
1202, 1206, 1208, 1209, 12XX 1. Dual Async Adapter/A
2. System Board
3. Any Serial Device
1207 1. Communications Cable
2. Dual Async Adapter/A
13XX 1. Game Adapter
1402
Printer not ready. Information only
1403
No-paper error, or interrupt failure. Information only
1404
System board timeout failure. 1. Run Enhanced Diagnostics
1405
Parallel adapter error. 1. Run Enhanced Diagnostics
1406
Presence test error. 1. Run Enhanced Diagnostics
14XX
Not listed above.
Check printer before replacing system
board. 1. See “Printer” on page 3-20
2. System Board
15XX 1. SDLC Adapter
1692
Boot sequence error. 1. Run FDISK to ensure at least one
active partition is set active
16XX 1. 36/38 Workstation Adapter
1762
Hard disk drive configuration error. 1. Run Configuration/Setup Utility (See
“Service Processor Configuration /
Setup Utility” on page H-9.)
1780 (Disk Drive 0)
1781 (Disk Drive 1)
1782 (Disk Drive 2)
1783 (Disk Drive 3) 1. See “Power-Supply” on page 3-21
2. Hard Disk Drive
3. System Board
4. Hard Disk Cable
5. Power Supply
180X, 185X
PCI configuration or resource error. 1. Run Setup and verify PCI/ISA
configuration settings
2. If necessary, set ISA adapters to "Not
available" to allow PCI adapters to
properly configure.
3. Remove any suspect ISA adapters.
4. Rerun diagnostics.
5. PCI Adapter
Chapter 3. Service Processor Troubleshooting
3-7