IBM 3745 Series, Installation And Maintenance Manual

Page: 137 / 270

Diagnostic Error Code FRU/Action
011-196-XXX
Serial port test halt, error threshold
exceeded 1. Depress F3 to review the log file.
See
“Viewing the Test Log” on
page 4-8.
2. Re-start the test to reset the log file.
011-197-XXX
Serial port test warning 1. Make sure component that is called
out is enabled and/or connected
2. Re-run test
3. Component that is called out in
warning statement
4. Component under test
011-198-XXX
Serial port test aborted 1. If a component is called out, make
sure it is enabled and/or connected
2. Flash the system and re-test
3. Go to “Undetermined Problems” on
page 3-23
011-199-XXX
Serial port test failed, cause unknown 1. Go to “Undetermined Problems” on
page 3-23.
2. Flash the system and re-test
3. Replace component under function
test.
011-2XX-XXX
Serial port signal failure 1. External serial device
2. System board
014-000-XXX
Parallel port Interface Test Passed 1. No action
014-001-XXX
Parallel port Presence 1. Remove external parallel device, if
present
2. Run setup, enable port
3. System board
014-002-XXX
014-003-XXX
Parallel port Timeout/Parity error 1. System board
014-013-XXX
014-014-XXX
Parallel port Control Signal/Loopback test
failure 1. System board
014-015-XXX
Parallel port External Loopback failure 1. Wrap plug
2. System board
014-027-XXX
Parallel port Configuration/Setup error 1. Run Setup, enable port
2. Flash the system
3. System board
014-03X-XXX
014-04X-XXX
Parallel port failure 1. System board
014-195-XXX
Parallel port Test aborted by user 1. Information
2. Re-start the test, if need to
014-196-XXX
Parallel port test halt, error threshold
exceeded 1. Depress F3 to review the log file.
See
“Viewing the Test Log” on
page 4-8.
2. Re-start the test to reset the log file.
Chapter 4. Service Processor Diagnostics and Test Information
4-15