IBM 3745 Series, Installation And Maintenance Manual

Page: 138 / 270

Diagnostic Error Code FRU/Action
014-197-XXX
Parallel port test warning 1. Make sure component that is called
out is enabled and/or connected
2. Re-run test
3. Component that is called out in
warning statement
4. Component under test
014-198-XXX
Parallel port test aborted 1. If a component is called out, make
sure it is enabled and/or connected
2. Flash the system and re-test
3. Go to “Undetermined Problems” on
page 3-23
014-199-XXX
Parallel port test failed, cause unknown 1. Go to “Undetermined Problems” on
page 3-23.
2. Flash the system and re-test
3. Replace component under function
test.
014-2XX-XXX
014-3XX-XXX
Parallel port failure 1. External parallel device
2. System board
015-000-XXX
USB port Interface Test Passed 1. No action
015-001-XXX
USB port Presence 1. Remove USB Device(s) and re-test
2. System board
015-002-XXX
USB port Timeout 1. Remove USB Device(s) and re-test
2. System board
015-015-XXX
USB port External Loopback failure 1. Remove USB Device(s) and re-test
2. System board
015-027-XXX
USB port Configuration/Setup error 1. Flash the system
2. System board
015-032-XXX
USB port Device Controller failure 1. System board
015-034-XXX
USB port buffer allocation failure 1. Reboot the system
2. Flash the system
3. Run memory test
4. System board
015-035-XXX
USB port Reset condition detected 1. Remove USB Device(s) and re-test
2. System board
015-036-XXX
USB port Register error 1. System board
015-040-XXX
USB port IRQ failure 1. Run setup and check for conflicts
2. Flash the system
3. System board
015-195-XXX
USB port Test aborted by user 1. Information
2. Re-start the test, if need to
015-196-XXX
USB port test halt, error threshold
exceeded 1. Depress F3 to review the log file.
See
“Viewing the Test Log” on
page 4-8.
2. Re-start the test to reset the log file.
4-16
3745-XXA 4-16 3746-9X0: 6563 SPIM