IBM 3745 Series, Installation And Maintenance Manual

Page: 163 / 270

After Battery or Board Exchange
You are here after battery or board exchange.
1. Power ON the service processor and its attached display.
2. A count of computer memory appears at the upper-left corner of the display.
3. If an error is detected, a message is displayed requesting an action. Select
Continue, then press Enter.
4. Follow the prompts to continue untill the Configuration/Setup Utility window is
displayed.
5. On the Configuration/Setup Utility window the area where the configuration
has been modified is pointed by an arrow. Refer to “Service Processor
Configuration / Setup Utility” on page H-9 to check the configuration and
correct it if necessary.
6. At the end of configuration, a message asks you if you want to save your
changes.
7. Select Yes and press Enter to reboot the service processor.
8. If you have changed the board go to Step 9. Otherwise, if you have changed
the battery, go to Chapter 6, “CE Leaving Procedure” on page 6-1.
9. Run the diagnostics on the service processor see “Starting the IBM PC
Enhanced Diagnostics Program” on page 4-4.
10. Is the diagnostic error free?
No Restart the problem determination.
Yes Return the service processor to the customer, then go to Chapter 6,
“CE Leaving Procedure” on page 6-1.
Chapter 5. Service Processor FRU / Display Exchange
5-15